Exterior Painting, Pressure Washing & Repairs in Atlanta, GA

Residential & commercial exteriors

Exterior Painting

Exterior paint has to survive sun, rain, and temperature swings. We prepare the surface properly — washing, scraping, sanding, caulking, and priming — before any finish coat goes on.

We work on homes, offices, and commercial buildings, protecting landscaping and walkways and keeping the site tidy throughout the project.

• Siding, stucco, brick, and masonry
• Trim, fascia, soffits, and columns
• Doors, shutters, and garage doors
• Commercial buildings and storefronts
• Washing, scraping, caulking, and priming
• Landscaping and walkway protection

Repair when we can, replace when we should

Wood Repair & Replacement

Some wood can be repaired and some has to go. We inspect each area first, save what is still sound, and replace the material that is too far gone to hold paint or keep water out.

Damaged siding and fascia are cut out and replaced with sound lumber, then the detail is rebuilt so it matches what was there before.

Once the carpentry is complete we prime and paint the repaired areas so the finish blends into the rest of the property.

• Wood repair and wood replacement
• Siding replacement
• Fascia board replacement
• Rotted and damaged wood removal
• Trim, soffit, and column repair
• Surface preparation
• Priming and painting after repairs

Repair, replace, clean & seal

Deck Maintenance

Decks take a beating from Georgia sun, rain, and temperature swings. Over time boards crack, railings loosen, and the wood turns gray or starts to rot. We inspect the structure, replace what is too far gone, and refinish what can be saved.

Rotted or split deck boards are removed and replaced with matching pressure-treated lumber. We also check joists, posts, and railings to make sure the deck is safe before any stain or sealer goes on.

Once repairs are done, the deck is cleaned and prepped. We then apply a quality stain or sealer that protects the wood from moisture and UV damage, extending the life of the deck and restoring its color.

• Deck inspection and safety check
• Deck board replacement
• Rotted wood removal and replacement
• Railing and post repair
• Deck pressure washing and cleaning
• Deck staining and sealing
• Wood protection and waterproofing
• Residential decks, porches, and patios

Fiber cement & full siding replacement

Siding Installation

When siding is past the point of patching, replacing it is the better investment. We install new siding on homes and commercial buildings, including fiber cement products such as James Hardie.

Fiber cement siding is made from cement, sand, and cellulose fiber. That mix is why it holds up the way it does: it will not rot, it does not feed termites, it will not burn, and it stands up to hail, wind, and hard Georgia sun far better than wood or vinyl. It also holds paint much longer, so repaint cycles stretch out instead of coming back every few years.

It comes in lap siding, vertical panels, shingle-look siding, and matching trim and soffit boards, with smooth or wood-grain textures. That means we can replace failing siding and still match the look of the house — or change the look completely if you want something different.

The installation is where it either lasts or fails. We remove the old siding, inspect and repair the sheathing and framing underneath, then install house wrap and flashing so water has a path back out. Planks go on with the correct fastening, spacing, and clearances, and we leave the proper gaps at trim, windows, doors, and roof lines instead of jamming boards tight.

Cutting fiber cement creates silica dust, so we cut with the right blades and dust control to keep the site and the crew safe. Seams and penetrations are flashed and caulked with a flexible exterior sealant, not filled with whatever is on the truck.

Because we are painters first, the finish is not an afterthought. Cut edges are sealed and primed, and the new siding is painted with a proper exterior system, so you get one crew responsible for the whole exterior instead of a siding installer and a painter blaming each other.

• Siding installation and full siding replacement
• Fiber cement siding, including James Hardie products
• Lap siding, vertical panels, and shingle-look siding
• Matching trim, fascia, soffit, and corner boards
• Old siding removal and haul-away
• Sheathing and framing repair before installation
• House wrap, flashing, and moisture detailing
• Caulking, sealing, and cut-edge priming
• Exterior painting of the new siding
• Residential and commercial buildings